High-quality copper-aluminum cables and their thick weave guarantee good conductivity, easy and quick use and long-term service life. High-quality insulated clamps ensure a firm grip of the terminals and minimize the risk of accidental short circuit. Thanks to the practical packaging, the cables will always be protected from dirt, securely secured and ready for repeated use.
Instructions for use:
- Both car batteries must have the same voltage.
- Start the engine of the car from which you want to run the voltage.
- Connect the red clamps to the positive (+) poles of both batteries so that they do not touch other parts of the vehicles.
- Connect the black clamps to the negative (-) poles of the batteries so that they do not touch the red clamps.
- If possible, let the engine of the vehicle from which you want to run the voltage run at high revs.
- If the vehicle does not start within 10 seconds, wait a minute and try again.
- After the vehicle has started, first disconnect the negative (-) poles and only then the positive (+). Keep in mind that the positive poles of the clamps must not touch the negative poles. The red clamps must not touch the metal parts of the vehicle.
Available in variants
- Booster cables with a maximum current load of 400 A, with a length of 2.5M, cable cross-section of 9mm²
- Booster cables with a maximum current load of 600 A, with a length of 4M, cable cross-section of 10mm²
